Advertisement
Set-Up and USage
q Assembling the Handlebars
Tools Needed: 10mm wrench
1
Align the holes on the handlebars and the T-tube. Insert handlebar bolts
into the top of the handlebar and through the T-tube. Install the washers
and nuts onto the bottom of the handlebar bolts. Tighten securely into place
using a 10mm wrench.
q Assembling the Rear Wheels
Tools Needed: (2) 10mm wrenches
outside
inside
3-2
3-4
3-3
3-1
1
Remove the locknut, spring washer and washers (x3) from one side of the axle bolt. Insert the axle bolt through
the rear wheel making sure the long spacer on the wheel (refer to arrow above) is facing towards the frame. Insert
the large washer (3-5) onto the axle bolt between the frame and rear wheel and slide the axle bolt through the frame.
Slide the other large washer and wheel (with the long spacer facing inwards towards the frame) onto the axle bolt.
2
Insert the small washer (3-3), spring washer (3-2) and locknut (3-1) onto
the axle bolt and tighten securely using (2) 10mm wrenches.
2
Place the handlebar pad over the
handlebars and secure tightly with
the velcro cover.
Frame
3-5
3
Make sure the locknut, spring
washer and small washer are securely
tightened against the wheel.
3
3-1
3-3
3-2
3-5
Note: For further assistance, please
refer to page 5 for parts breakdown.
Rear wheel hardware sequence
3-1 - Locknut
3-2 - Spring washer
3-3 - Washer (small)
3-4 - Axle bolt
Wheel
3-5 - Washer (large)
Advertisement
