Advertisement
SET-Up aND USagE
q attaching the Foot platforms
1
Using two 5mm hexagonal
wrenches, remove the two
hexagonal bolts and the two
coupling bolts from the frame.
q attaching the Handlebars
1
Remove the plastic protector
covering the wedge and loosen the
black folding knob and swing to
the 6 o'clock position to unfold the
handlebar stem.
4
Using a 6mm hexagonal key
wrench to tighten the stem
bolt. The stem bolt is properly
tightened when the handle-
bars cannot be twisted out of
alignment with the front wheel.
Make sure the handelbars are in
line with the front wheel before
tighten stem bolt all the way.
2
Position the right and left foot
platforms up to the frame and
align holes.
2
Insert the handlebar stem into
the front fork. You may have to
loosen the wedge to allow it to
slip into the front fork.
5
Bring the handlebar stem
back to the upright position.
3
Insert the two coupling bolts
and two hexagonal bolts. Starting
underneath with the bolt on the
back. Turn product over and insert
the next set of bolts. Tighten with
two 5mm hexagonal wrenches.
3
Slide the handlebar stem
down into the front fork until
it fits snuggly into the lock
nut on the headset.
6
Swing the black folding knob
to the 12 o'clock position and
tighten by hand until handlebars
are secure.
3
WaRNINg: Failure
to properly tighten the wedge
may allow the handlebars to
dislodge while riding and may
cause you to lose control and
fall. When correctly tightened,
the handlebars will not rotate
out of alignment with the
front wheel under normal
circumstances.
WaRNINg: Keep your
fingers clear of the pivoting
mechanism when folding or
unfolding the scooter, and make
sure others are standing clear.
Note: The cable and wire
assembly from the handlebar
must not wrap around the
steering tube or handlebar as
shown in step 3. Sharp bends or
twisting of the brake cable can
cause the brake to malfunction.
Advertisement
