Assembly And Set-Up/Usage; Attaching The Handlebars - Razor E300 Series Owner's Manual

ASSEMBLY AND SET-UP
q Attaching the Handlebars
Tools required: 5 mm Allen wrench.
1
Loosen the collar clamp and
slide it upward. With a twisting
motion, push and twist to slide
the steering tube onto the fork.
q Inflating the Tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of
manufacturing and your purchase. Always inflate tires to the correct PSI before first time use.
Rear Tire
1
Use the valve extender
located inside the end of
the right handlebar grip.
Front Tire
4
Using a bicycle tire pump equipped for a
Schrader valve, inflate the front tire to the
PSI indicated on the sidewall of the tire.
2
With the front wheel pointed
straight ahead and the handle-
bars square to the front wheel,
tighten the clamp as shown.
Tighten securely.
2
Open the round cover
located on the chain cover
by sliding the cover upward.
Align the opening in the drive
sprocket with the valve stem.
Thread the valve extender
completely onto the valve stem
and attach the pump. Inflate
to the PSI indicated on the tire
sidewall.
3
Remove valve extender
immediately after inflating and
close the round cover.
3
Meijer.com
Note: Make sure the cables/
wires are out of the way before
inserting the stem in the fork.
WARNING: Failure to
properly tighten the collar clamp
may allow the handlebars to
dislodge while riding and may
cause you to lose control and
fall. When correctly tightened,
the handlebars will not rotate
out of alignment with the
front wheel under normal
circumstances.
Note: The cable and wire
assembly from the handlebar
must not wrap around the
steering tube or handlebar.
Sharp bends or twisting of
the brake cable can cause the
brakes to malfunction.
WARNING:
Failure to remove the valve
extender after inflating will
cause the inner tube and/or
adapter to be severed by the
rear drive sprocket.
Note: If you lose the valve
extender, contact customer
service or one can be purchased
at almost any auto parts store.
WARNING:
Do not over inflate, as this
could damage tire or wheel
Note: The pressurized air
supplies found at gasoline
stations are designed to inflate
high-volume automobile tires.
If you decide to use such an air
supply to inflate your electric
scooter tires, first make sure
the pressure gauge is working,
then use very short bursts to
inflate to the correct PSI. If you
inadvertently over-inflate the
tire, release the excess pressure
immediately.