Table of Contents
Advertisement
10. Help
10 Help
Error Messages
10.1 Error messages – Reports
If a problem occurs during fax transmission or reception, one of the following messages will be printed on the sending
and journal reports (page 43).
Message
COMMUNICATION ERROR
DOCUMENT JAMMED
ERROR-NOT YOUR UNIT
MEMORY FULL
NO DOCUMENT / FAILED PICKUP
OTHER FAX NOT RESPONDING
PRESSED THE 'Stop' KEY
THE COVER WAS OPENED
OK
76
Code
Cause & Solution
40-42
L A transmission or reception error occurred. Try
46-72
again or check with the other party.
FF
43
L A line problem occurred. Connect the telephone line
44
cord to a different socket and try again.
L An overseas transmission error occurred. Try using
the overseas mode (feature #411 on page 59).
-----
L Remove the jammed document (page 95).
53
L A transmission or reception error occurred because
54
of a problem with the other party's fax machine.
59
Check with the other party.
70
-----
L The memory is full of received documents due to a
lack of recording paper or a recording paper jam.
Load paper (page 13) or remove the jammed paper
(page 89).
L If the PC fax setting (feature #442 on page 62) is set
to "ALWAYS", check the connection between the
computer and the unit.
L If the fax preview mode (feature #448 on page 53) is
set to "ON", view, print or save the documents on the
web browser, and then erase unnecessary
documents (page 53).
-----
L The document was not fed into the unit properly. Re-
insert it and try again.
-----
L The other party's fax machine is busy or has run out
of recording paper. Try again.
L The other party's fax machine rings too many times.
Send the fax manually (page 43).
L The other party's machine is not a fax machine.
Check with the other party.
L The number you dialled is not in service.
-----
L {W} was pressed and fax communication was
cancelled.
-----
L The left cover was opened. Close it and try again.
-----
L Fax transmission or reception was successful.
Hide quick links:
Advertisement
Table of Contents
