(34) Remove tape.
(35) Fix the original feed tray temporally by
screw (M4 × 6, silver, 2)
(36) Adjust the original feed tray.
. Prepare an A4 (or Letter) sized test original
by drawing a line in the center of the sheet,
as shown.
. Place the test original 1 face up in the tray.
Adjust the side guides to the edges of the
original.
. Press PRINT to make a copy. Fold the copy
in half to check that the center line is cop-
ied in the center of the sheet.
If not, loosen the two screws and adjust the
position of the original feed tray. Repeat the
procedure until the center line on the copy
is in the fold. After the adjustment, tighten
the two screws of the original feed tray.
Nov. 1997 © TOSHIBA
17 - 29
3560/70 INSTALLATION