Sony STR-DH710 Operating Instructions Manual page 93

The ROS information that you want
does not appear.
*
• Contact the radio station and find out
whether they actually provide the service
in question. If so, the service may be
temporarily out of order.
*
Models of area code AU I, SA2. TW2 only.
The source sound input to the HOMI
jack is not output from the receiver or
the TV speaker.
• Check the HDMI connection (page 24).
• You cannot listen to the Super Audio CD
by connecting HDM!.
• Depending on the playback component,
you may need to set up the component.
Refer to the operating instructions
supplied with each component.
• Be sure to use a High Speed HDMI cable
when you view images or listen to sound
during Deep Color (Deep Colour)
transmission.
The source image input to the HOMI
jack is not output from the TV.
• Check the HDMI connection (page 24).
• Depending on the playback component.
you may need to set up the component.
Refer to the operating instructions
supplied with each component.
• Be sure
to
use a High Speed HOMI cable
when you view images or listen to sound
during Deep Color (Deep Colour)
transmission.
The Control for HOMI function does not
work.
• Check the HDMI connection (page 24).
• Make sure "CTRL.HDMI" is set to
"CTRL ON" in the HOMI menu.
• Make sure the connected component is
compatible with the Control for HOMI
function.
• Check the Control for HOMI settings on
the connected component. Refer to the
operating instructions of the connected
component.
• Repeat the procedures of "Preparing for
the "BRA VIA" Sync" if you change the
HDMI connection, connect/disconnect the
AC power cord (mains lead), or when
there is a power failure (page 55).
No sound is output from the receiver
and TV speaker while using the System
Audio Control function.
• Make sure the TV is compatible with the
System Audio Control function.
• If the TV does not have System Audio
Control function, set the "AUDIO.OUT"
settings in HOMI menu to
- "TV+AMP" if you want to listen to the
sound from the TV speaker and receiver.
- "AMP" if you want to listen to the sound
from the receiver.
• When you connect the receiver to a video
component (projector, etc.), sound may
not be output from the receiver. In this
case, select "AMP".
• If you cannot listen to the sound of a
component connected to the receiver
- Change the input of the receiver to
HDMI when you want to watch a
program on a component connected via
HDMI connection to the receiver.
- Change the TV channel when you want
to watch a TV broadcast.
- Select the component or input you want
to watch when you watch a program on
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
-
»
a.
a.
::J
-
o
.,
3
D)
=:
o
::J
conffnued-----------