Sony STR-DH710 Operating Instructions Manual page 36

Measurement process Explanation
[Display]
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
3:· . .
C ~~I~!.lJli~lIsavi .. git~«,
measurel11enf:resldtS .
1
Confirm the measurement
result.
1
Press AMP MENU.
2
Press
+1+
repeatedly to select
"A. CAL", then press
8
or +.
"STAR
r'
appears on the display.
3
Press
8.
Measurement starts in 5 seconds. A counl
down is displayed.
The measurement process will take
approximately 30 seconds to complete.
The table below shows the display when
measurement starts.
Completes properly
[SAVE.EXIT]
Proceed to step 2.
*
The corresponding speaker indicator lights
up in the display during measurement.
Item and explanation
View the measurement result.
Press
+1+
repeatedly to select the item.
Then, press
8.
Measurement for
Speaker existence
Speaker gain, distance,
frequency response
Subwoofer gain and distance
Display
TONE
T. S. P.*
WOOFER*
2
Fails
[E- • • • • •]
See "When error
codes appear"
(page 37).
Tips
• Operations other than turning the receiver on or off
are deactivated during the measurement.
• The measurements may not be performed correctly
or Auto Calibration cannot be performed when
special speakers, such as dipole speakers are used.
To cancel Auto Calibration
The Auto Calibration function will be
canceled when you do the following during the
measurement process:
- Press
1/6.
- Press the input buttons or turn the INPUT
SELECTOR on the receiver.
- Change the volume level.
- Press MUTING (RM-AAU073 only) or
[]*
(RM-AAU075 only).
- Press the SPEAKERS button on the receiver.
- Connect headphones.
36
GB
EXIT
Exits the setting process without saving the
measurement results.
LVL INFO.
Displays the measurement result for speaker
level.
DIST.lNFO.
Displays the measurement result for speaker
distance.
P.INFO.
Displays the phase of each speaker (in phase/
out of phase). See "When you select ·'P.
INFO."" (page 38).
WARN CHK
Displays warning concerning the
measurement results. See "When you select
"w
ARN CHK'''' (page 38).
SAVE.EXIT
Saves the measurement results and exits the
setting process.
RETRY
Performs the Auto Calibration again.