Remote Controller; Room Temperature - Hitachi RAS-SX10HAK Instruction Manual

NAMES AND FUNCTIONS OF EACH PART (continued)

REMOTE CONTROLLER

Transmits the operation and timer settings to the indoor unit.
The LCD shown in the illustration below is the display immediately after the reset switch is pressed. Usually not
all the data are displayed. On the LCD shown below, the functions not available for this room air conditioner are
also displayed.
BUTTONS TO
START OPERATIONS
DEHUMIDIFY Button
Press this button to start
dehumidifying operation.
(Page 14)
HEAT Button
Press this button to start
heating operation.
(Page 14)
COOL Button
Press this button to start
cooling operation.
(Page 15)
DRY COOL Button
Press this button to start dry
cool operation. (Page 16)
AUTO Button
Press this button to
start automatic operation.
(Page 13)
Remote controller can be used when it is fixed on a wall or pillar using the remote controller holder.
Before fixing it, make sure the indoor unit can be controlled from the remote controller fixing point.
Screw
Transmission Part
AIR CLEANING Button
Press this button to start plasma air
cleaning (air circulation) operation.
(Page 18)
– 6 –
Transmission Indicator
The transmission indicator
lit when a signal is sent.
STOP Button
Press this button to stop any
operation except the preset timer.

ROOM TEMPERATURE

Button
Press this button to set the
room temperature. Keep
pressing and the value will
change more quickly.
HUMIDITY Button
Press this button to set the
humidity for dehumidify and
dry cool operations.
INFRARED HUMAN-PRESENCE
SENSING Button
Press this button to enter
the dynamic air deflection mode.
(Page 19, 20)
SLEEP TIMER Operation Button
Press this button to start sleep timer
operation. (Page 29)