Heating Operation; Dehumidifying Operation - Hitachi RAS-SX10HAK Instruction Manual

HEATING OPERATION

Press the (HEAT) button to start heating operation.

DEHUMIDIFYING OPERATION

3 types of dehumidifying operations can be performed by pressing the
Performs powerful dry operation without lower down the room temperature.
STOP
Press the (HEAT) button.
• Adjust the room temperature and fan speed to your preference.
Temperature range between 16°C~32°C can be set.
Press the (STOP) button.
STOP
•
A short beep sounds and heating operation stops.
Press the (DEHUMIDIFY) button.
• Every time you press the •
the mode will change as shown in the chart below.
Auto Quick
Dehumidifying
Laundry
("AUTO" flashes for 5 seconds)
• In auto dehumidifying mode, fine adjustment of room temperature,humidity
adjustment and fan speed selection can be made to your preference.
Every time you press the ROOM TEMPERATURE button, the temperature will change
by 1°C. (Temperature setting range is not higher or lower than 3°C.) Every time
you press the HUMIDITY button, the humidity will change by 5%. (Humidity setting
range is 40%~70%.)
• In quick laundry mode, fine adjustment of room temperature and fan speed
selection can be made to your preference. (Fine adjustment of room
temperature and humidity adjustment cannot be made in condensation
control mode.)
Press the (STOP) button.
• A short beep sounds and dehumidifying operation stops.
• • After the dehumidifying operation is stopped, the remote controller will display the
operation mode that had been set before the
pressed.
– 14 –
(DEHUMIDIFY) button.
(DEHUMIDIFY) button,
Condensation
Control
(DEHUMIDIFY) button was