Adjusting The Horizontal Airflow Direction - Hitachi RAS-SX10HAK Instruction Manual

ADJUSTING THE HORIZONTAL AIRFLOW DIRECTION

CAUTION
Do not operate long hours with cooling, dehumidifying, dry cool operation and horizontal airflow swing
operation.
Some dew may form on the horizontal air deflector and drop which may wet your furniture.
In the following cases, the swing stops even when vertical swing and horizontal swing are set.
In Heating operation
• During preheat operation.
• During defrost operation.
• When the room temperature
reaches the temperature which
had been set.
Adjust the horizontal airflow direction
• The angle of horizontal airflow direction is set to the front at the
time of purchase.
• Every time the button is pressed, the mode of the horizontal air deflector
changes as below.
• A short beep sounds and the angle of the horizontal air deflector changes.
Front
Horizontal
swing
• The movements of the left and right air deflectors displayed in the remote controllers
are not synchronous with movements of the actual air deflectors.
Horizontal angle of your preference
•
To set the horizontal airflow direction to your desired angle, move the
horizontal air deflector and press the
again to stop air deflector's movement once it has reached your desired
angle.
•
The movement scope of the left/right air deflectors are set to the following
5 positions:
Press the (HORIZONTAL AIRFLOW) button again to fix your preferred
angle during horizontal airflow swing.
• Fan speed may be increased depending on the angle of the horizontal air
deflector.
• Even if the horizontal airflow direction has been adjusted to your desired
angle, the angle of horizontal air deflector may change in the event the room
temperature and humidity continue to be high during cooling, dehumidifying
or dry cool operation. The angle will change back to your desired angle once
the temperature and humidity have been lowered by the air conditioning
operation.
In Dehumidifying operation
• When the humidity is reached
to the humidity which has been
set.
• When the room temperature is
below 1°C.
– 25 –
preferred angle
(HORIZONTAL AIRFLOW) button
In Dry Cool operation
• When the temperature is below
the temperature which has been
set and the operation is stop.