Table of Contents
Advertisement
USING
MULTIPLE
CRADLE
If you want to use several readers associated with the same cradle, you must
first Bind the cradle with one of the readers (see previously described
configuration procedure).
Successive readers can be associated with the same cradle by following the
configuration procedure substituting the Bind command with Join.
5.
The green LED on the Gryphon™ M will blink: the reader is ready to be
positioned onto the cradle. Complete step 6.
CAUTION
GRYPHON™ M DEFAULT CONFIGURATION
DATA FORMAT
code identifier disabled (enabled for POS terminals), field adjustment
disabled, code length tx not transmitted, character replacement disabled,
address stamping disabled; address delimiter disabled,
POWER SAVE
scan rate 270 scans/s; sleep state/USB suspend disabled, enter sleep
timeout = 0.6 sec
READING PARAMETERS
hand-held operation = hardware trigger, stand operation = automatic, trigger
active level, no timeout, Flash On = 1 sec, Flash Off = 0.6 sec, one read per
cycle, safety time 0.5 sec, beeper intensity high, tone 2, beeper type
monotone, beeper length short, low PDF decoding recognition intensity,
good read spot duration medium, automatic operation aiming light enabled.
DECODING PARAMETERS
ink spread enabled, overflow control enabled, interdigit control enabled,
Puzzle Solver™ disabled, decoding safety = one read
Ì$+RN1$-NÎ
If the cradle is not Bound to a reader, its address assumes
a random value, which can cause conflicts and malfunctions
to other cradles within its range.
READERS
Join
GRYPHON™ MX30
WITH
SAME
5
Advertisement
Table of Contents
