Hardware Installation; Physical Installation - Planet ICA-HM351 User Manual

2.3 Hardware Installation

16B

2.3.1 Physical Installation

38B
1. Fix IR camera to desired location with wall mount fixture
2. Plug-in Ethernet Cable into RJ-45 connector
Connect an Ethernet cable to the LAN socket located on the Network Camera's back panel
and attach it to the network.
If there has an IEEE 802.3af PoE switch in your network, you can connect the
NOTE:
camera LAN cable to this PoE switch to obtain power. The power adapter is
unnecessary when internet camera is connected to a PoE switch.
3. Connect RS485 D+ and D- (if you need to control PT scanner)
4. Attach the power supply
Connect the attached power adapters to camera and heater and plug-in these adapters into
power outlet
1. Only use the power adapter supplied with internet camera. Otherwise, the product
NOTE:
may be damaged.
2. The power adapter is unnecessary when internet camera is connected to a PoE
switch. Otherwise, the product may be damaged when internet camera is connected
to a PoE switch and power adapter simultaneously.
5. Attach BNC connector (option)
Connect the video BNC connector to a monitor set if necessary check camera viewing angle
and focus.
6 Attach Speaker to camera (option)
If user needs not only video stream but also audio stream, then the speaker should be
attached to camera.
7. Done
11