Table of Contents
Advertisement
Audio Output
(Green, Line Out)
Microphone Input
(Pink, Audio In)
Video Output
(BNC)
Reset
(Factory Default)
DI/DO, RS-485
DC Power
(Power Jack, Fan and
Heater)
Terminal block for I/O connectors:
Name
12VDC
GND
D+
D-
DI
DO
Note：ONLY use one power source, either from DC or from
802.3af Power over Ethernet.
Connect a loud speaker to the IP Camera. This is for voice
alerting and two-way audio.
Connect a microphone to the IP Camera.
The Network Camera also provides composite video output.
The video output function is only for easy installation to check
view angle and focus. Furthermore, only "720p Mode"
supports this function.
This button is used to restore the all factory default settings.
Sometimes restarting the device will make the system back to
a normal state. However, if the system still got problems after
restart, user can restore the factory default settings and install
it again.
Restore the device:
a.)
Press the button down continuously.
b.)
Hold the button at least 5 seconds and release it.
Then the device has been restored to default
settings and reboot again.
Note: Restoring the factory default setting will lose the all
previous settings included IP address forever. User needs to
run the IPWizard program to search the device and configure
it to let the device work properly again.
Connect RS-485 to external scanner and connect to sensor in
and alarm out devices.
The input power is DC 12V, 1A for Fan and Heater.
Note：That supplies the power to the built-in heater with the
power adapter included in package.
Cable Color
Brown/White
DC 12V (50mA maximum)
Blue/White
GND
Purple/White
RS485 data +
Gray
RS485 data -
Green/White
Digital signal input
Orange/White Digital signal output
10
Function
Advertisement
Table of Contents
