Hardware Installation; Installing Camera With Screws; Network Installation - Planet ICA-3110 User Manual

Audio Out

2.2 Hardware Installation

2.2.1 Installing camera with screws

1. Attach the Camera to the stand included.
2. Place the Camera on the table or fix it onto the ceiling or wall
Use three screws to fix the Network Camera onto the ceiling or wall. You could also put the
Network Camera on the table directly.

2.2.2 Network Installation

1. Connecting an Ethernet cable
Connect the LAN cable on the camera to the network device (hub or switch).
If there is an IEEE802.3af PoE switch in your network, you can connect the
camera LAN cable to this PoE switch to obtain power. The power adapter is
unnecessary when Internet camera is connected to a PoE switch.
2. Attach the power supply
Plug in power adapter and connect to power source. After power on, the camera will start
to operate.
four-colored wires are used for I/O connection. About I/ O
setting.
Name
GND GND
DI Digital signal input
DO Digital signal output
Audio-out jack allows this device to output audio signal.
HD Ultra-mini Bullet IR IP Camera
Function
ICA-3110
Fasten it
with Screws