Table of Contents
Advertisement
Forgot the IP address of the
device.
IPWizard program cannot find the
device.
Internet Explorer does not seem to
work well with the device
IPWizard program fails to save the
network parameters.
Can not work with NAT router
Some IP cameras are working but
others are failed
Cannot access the login page and
other web pages of the Network
Camera from Internet Explorer
2. Reconfigure the device.
Check IP address of device by using the IPWizard program or by
UPnP discovery or set the device to default by Reset button.
Re-power the device if cannot find the unit within 1 minutes.
Do not connect device over a router. IPWizard program cannot
detect device over a router.
If IP address is not assigned to the PC which running IPWizard
program, then IPWizard program cannot find device. Make sure
that IP address is assigned to the PC properly.
Antivirus software on the PC might interfere with the setup
program. Disable the firewall of the antivirus software during
setting up this device.
Check the firewall setting of your PC or Notebook.
Make sure that your Internet Explorer is version 6.0 or later. If you
are experiencing problems, try upgrading to the latest version of
Microsoft's Internet Explorer from the Microsoft webpage.
Network may have trouble. Confirm the parameters and connections
of the device.
UPnP NAT Traversal
Maybe NAT router does not support UPnP function. Please check
user's manual of router and turn on UPnP function.
Maybe too many IP cameras have been installed on the LAN, and
then NAT router is out of resource to support more cameras. You
could turn off and on NAT router to clear out of date information
inside router.
Access this device
Maybe the IP Address of the Network Camera is already being
used by another device or computer. To confirm this possible
problem, disconnect the Network Camera from the network first,
and then run the PING utility to check it out.
Maybe due to the network cable. Try correcting your network
cable and configuration. Test the network interface by connecting
a local computer to the Network Camera via a crossover cable.
Make sure the Internet connection and setting is ok.
Make sure enter the IP address of Internet Explorer is correct. If
the Network Camera has a dynamic address, it may have
changed since you last checked it.
Network congestion may prevent the web page appearing
quickly. Wait for a while.
90
Advertisement
Table of Contents
