Table of Contents
Advertisement
Operation Manual
PM200/250
Covert Off – Remotely turns the radio covert mode off, i.e. the radio will return back to
passive receive mode.
Selcall Text
When the correct Selcall tone set is received, the text is displayed. Up to 8
characters/numbers.
Decode Control 1-4
There are four control decode addresses that can be assigned. Up to 8 tones can be use in
the decode address 0-9 and A-E can be entered. There are three actions/timings
associated with control 1-4 decode addresses. (See Call 1-3 for actions/timings).
Group Call
The group call is normally reserved for multiple calls. (See decode Call 1-3 for actions /
timings).
Decoder Tone Length
This is the time of the standard tone length, note that tone length timings will change
automatically depending on encode tone set selection.
Covert RX on time Amount of time the receiver is active in covert mode. 0-250 seconds.
Covert TX on time Amount of time the transmitter is active in covert mode. 0-250 seconds.
Received Message Selection
The radio can store up to 5 received selcall messages. The oldest message is erased when
the 6th message is received. However, once the radio is powered off, all messages are
cleared. To see stored messages
Press pre-programmed Selcall key and use ▲▼ to select "Received" for stored
messages.
Press pre-programmed Selcall to enter stored message list.
Press ▲▼ to select the desired stored message.
Press Selcall again to return to the standby condition.
Page 21 of 33
Advertisement
Table of Contents
