Glass Removal - Majestic 300DVBLN/PSC Installation And Operating Instructions Manual

GLaSS remoVaL

GLaSS Frame remoVaL
1. Remove access panel by lifting up and out.
. Release two clamps (500 model has three clamps) on
bottom of fireplace. Figure 33
3. Tilt glass frame out and lift glass frame up until it clears
three tabs on top of fireplace.
4. Set glass frame aside.
each clamp has a quick spring
force. when reinstalling clamps,
keep fingers clear.
Figure 33 -
Removing Glass Frame
WARNING
!
note: A mesh glass cover is available for this fireplace.
This cover is recommended to reduce the severity of burns
in case of accidental contact. Refer to the Accessories list
on Page 49.
eyeBrow/canopy InStaLLatIon
1. Remove glass frame.
. Hold eyebrow/canopy with groove facing up and tabs
for screws facing down. Figure 34
3. Install by placing eyebrow under bottom lip of facing.
Hook bottom lip of facing into groove of eyebrow. Pull
eyebrow forward until it stops. Figure 34
4. Insert self-tapping screws into tabs on bottom of eye-
brow and into sides of facing.
note: Eyebrow/canopy is optional depending upon clear-
ances to combustible mantels and trim. Refer to Page 9.
74D3001
Glass Frame
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Clamps
Facing
FP2339
glass frame
Eyebrow/Canopy
eyebrow/canopy
Figure 34
FP2905
eyebrow canopy
DVBL7 Series Gas Fireplace
FP339
Tabs for
Screw
Groove
Tab
5