Switching.on/Off; Wet.vacuuming; Dry.vacuuming; Blowing - Parkside PNTS 1300 B2 Operation Manual

GB IE
- Material filter (
vacuuming
- Paper filter bag for fine dust
( 17)
Never.vacuum.without.a.filter!
4. Place the motor housing (1) on
top of the dirt collector (6) and
close it with the clip (9).
The.fastening.clips.must.
be.hooked.into.the.snap-in.
points.provided.
5. Connect the vacuum hose (13)
and the accessories.
Switching on/off
Connect the mains plug.
Switching.on.the.vacuum:
On / off switch (
Switching.off.the.vacuum:
On / off switch (
Wet vacuuming
In order to wet vacuum, attach the foam
filter (15) onto the filter tray. Only use a
dry filter.
If the waste tank is full, a float clos-
es the suction opening, and the
vacuum operation is interrupted.
Switch off the machine and empty
the waste tank.
If foam or liquid exits, switch off the
machine immediately.
Dry vacuuming
For dry vacuuming, pull the material filter
(16) over the filter basket.
8
16) for dry
3) in position "I"
3) in position "O"
Fine.dust.vacuuming:
When vacuuming very fine dust,
you may find dirt accumulating
more quickly than usual. We there-
fore recommend additional use of
the paper filter bag.
Insert.the.fabric.filter.
1. Pull the material filter (16) over the
filter basket.
Insert.the.paper.filter.bag
2. Fold down the side flaps (21) on the
paper filter bag (17) at the perforation.
3. Fit the paper filter bag (17) with the
short flap upwards over the internal
suction pipe (22) (see arrow
The sealing ring (23) at the filter bag
opening must completely surround the
lip on the suction pipe.

Blowing

To blow, plug the suction hose (13) onto
the connection (10) on the motor head.
Cleaning/Maintenance/
Storage
Pull out the mains plug.
This will prevent danger of injury
from electric shock.
Always check the appliance before
use for any obvious faults such as
a defective mains cable, and have
these repaired or replaced.
).