Topten TK310 User Manual page 14

Presetting by SMS for GPRS tracking (Ensure that your SIM card supports GPRS connection prior to setting)
Set ID for TK310
Set APN
Set IP Address and Port
Enable GPRS Tracking
Function
Set Time Interval for
Sending GPRS Packet
For more information regarding GPRS settings please refer to <GPRS Communication Protocol>
Output Control
Output Control (Safe
mode)
This function is achievable
when the speed is below
10km/h and GPS
available.
Set sleep mode
for saving power
Set power saving mode
when TK310 is inactive
(In power saving mode, GPS
stops working. GSM enters
standby mode and stop
sending out message until it
is activated by an SMS or an
incoming call)
W******,010,ID
W******,011,APN,APNName,APN
Password
W******,012,IP, Port
W******,013,X
W******,014,XXXXX
W******,020,P,F
W******,120,ABCDE
is
W******,021,XX###
W******,026,XX
TOPTEN GPS
Tracker ID must not over 14 digits.
If no APN name and
required, just insert APN only;
APN defaulted as 'CMNET';
APN + APN name + password not over
39 characters.
IP: xxx.xxx.xxx.xxx Port: [1,65534]
X=0, close GPRS (default);
X=1, enable TCP
X=2, enable UDP
XXXXX should be in five digitals and in
unit of 10 seconds.
XXXXX=00000, to close this function;
XXXXX=00001~65535, time interval for
sending GPRS packet and in unit of 10
seconds.
P =1, Out1
=2, Out2
=3, Out3
=4, Out4
=5, Out5
F =0, to close the output
=1, to open the output
ABCDE represents Out1, Out2, Out3,
Out4, and Out5 respectively.
If A or B or C or D or E,
=0, to close the output
=1, to open the output
=2, to remain previous status
XX=00 turn off sleep mode
XX=01 sleep mode
XX=02 deep sleep mode
### is the ending character
XX=00, to turn off this function
XX=01~99, to set this function. It is in
unit of minute.
Example:
If XX=10, TK310 will enter power
saving mode after it is immobile for 10
minutes.
password
- 14 -