Invacare Pronto M51 Base Owner's Operator And Maintenance Manual page 37

Connected Devices Screen
NOTE: For this procedure, refer to FIGURE 5.8.
This screen is displayed if the Mode Select switch is held active for about 10 seconds. This
screen shows an icon that represents any additional devices that are connected to the
chair.
FIGURE 5.8 LCD Display Screens - Connected Devices Screen
Programmable Mono Port 1/2 or External Mode Switch
The programmable mono port or external mode switch input is located at the rear of the
joystick on the left side. The programmable mono port input offers the choice of three
options:
• Remote drive select
• Remote stop/mode (reset) input
• Single actuator input
The single switch functions operate through mono port 1. An optional y‐cable allows a
second programmable function through mono port 2.
Remote Stop Switch
The remote stop switch is used to stop the wheelchair.
Remote Mode (Reset) Switch
The remote mode reset switch functions the same way as the mode switch. Refer to Mode
Switch on page 38.
Part No. 1148076
SECTION 5—WHEELCHAIR OPERATION
ICON
4-Switch Attendant Control
RIM Control
ECU (1 to 4)
Proportional Attendant Control
Compact Joystick
Sip and Puff Control
ASL Digital Control
ASL Analog Control
Shark Power Module Actuator
37
Pronto
DESCRIPTION
® ™
M51 Base with SureStep
®