SECTION 8—TOP SHROUD AND
WHEELS
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
Replacing the Flat Free Tires on the Wheel Rim
DO NOT attempt to replace flat free tires. This procedure MUST be performed by
a qualified technician.
NOTE: During initial use of the wheelchair, the user may experience flat spots on the wheels. Flat
spots will vanish with continued use of the wheelchair.
Removing/Installing the Battery Shroud
NOTE: For this procedure, refer to FIGURE 8.1 on page 48.
Removing
1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joysticks on page 40.
2. Perform one of the following:
• Tilt the seat assembly to the up position. Refer to Tilting the Seat Assembly
(Formula CG Only) on page 41.
• Remove the seat assembly from the wheelchair. Refer to Removing/Installing the
Seat Assembly on page 43.
3. If Installed, disconnect the powered seating system.
4. Lifting up to release the hook and loop straps, remove the battery shroud from the
base frame.
Part No. 1148076
SECTION 8—TOP SHROUD AND WHEELS
WARNING
WARNING
47
®
™
Pronto
M51
Base with SureStep
®