Repositioning Joystick - Invacare Pronto M51 Base Owner's Operator And Maintenance Manual

Repositioning Joystick

NOTE: For this procedure, refer to
FIGURE 5.9.
1. Turn the adjustment lock lever to
release the joystick mounting tube from
the mounting bracket.
2. Remove the joystick from the wheelchair.
3. Remove the three hex screws that
secure both halves of the mounting
bracket to the arm tube.
4. Reposition mounting bracket on
opposite arm tube ensuring the
threaded plate of the mounting bracket
is on the inside of the arm tube as
shown in FIGURE 5.9.
5. Using the three hex mounting screws and washers, secure both halves of the mounting
bracket to the arm tube.
6. Slide the joystick mounting tube through the mounting bracket to the desired position.
7. Turn the adjustment lock lever to secure the joystick mounting tube into the mounting
bracket.
Part No. 1148076
SECTION 5—WHEELCHAIR OPERATION
Mounting
Bracket
Washers
Adjustment
Lock Lever
Hex Mounting
Screws
FIGURE 5.9 Repositioning Joystick
39
Pronto
Mounting Bracket
(Threaded Plate)
Arm Tube
NOTE:
Joystick
not shown.
Joystick Mounting Tube
® ™
M51 Base with SureStep
®