SECTION 9—BATTERIES
Using the Proper Batteries
NOTE: For this procedure, refer to FIGURE 9.1.
1. Place battery on ground/flat surface.
2. Visually draw a horizontal and vertical centerline through the middle of battery
(FIGURE 9.1).
3. Position the battery so that the terminals are above the horizontal centerline.
4. Visually inspect the battery to ensure the correct position of the POSITIVE and
NEGATIVE terminals (FIGURE 9.1).
Batteries with terminal configuration as shown below MUST be used. Batteries that
have the reverse terminal configuration MUST NOT be used - otherwise injury and
damage may occur.
Use This Configuration
U1 Battery
®
™
Pronto
M51
Base with SureStep
WARNING
NEGATIVE (-)
Battery Terminal
NEGATIVE (-)
Battery Terminal
POSITIVE (+)
Battery Terminal
FIGURE 9.1
Using the Proper Batteries
®
DO NOT Use
52
POSITIVE (+)
Battery Terminal
U1 Battery
Part No. 1148076