Electrical Connection - SCHOLTES B 40 L EC.1 SF Operating Instructions Manual

Gas Hob Operating Instructions

Electrical Connection

The hobs come equipped with a 3 pin plug and
power cable. The plug and power cable comply
with Australian requirements. Please check the
power rating, voltage and frequency indicated on
the data plate (located on the bottom of the hob
as well as on the front cover of this manual).
If the appliance is to be installed above an electric
built-in electric oven, the electrical connection to
the hob and oven must be carries out separately,
both for electrical safety purposes and to make it
easier to remove the oven.
The supply cable must not come into contact with
surfaces higher than 50°C.
! The installer must ensure the electrical
connection has been made and is compliant with
AS/NZS 3000 wiring rules.
Before connecting to the power supply, make sure
that:
The appliance is earthed and the plug is
•
compliant with the law.
The socket can withstand the maximum
•
power of the appliance, which is
indicated on the data plate.
The voltage is in the range between the
•
values indicated on the data plate.
The socket is compatible with the plug of
•
the appliance. If the socket is
incompatible with the plug, ask an
authorised technician to replace it. Do
not use extension cords or multiple
sockets.
! Once the appliance has been installed, the
power supply cable and the electrical socket must
be easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and
replaced by authorised technicians only (see
Assistance).
! The manufacturer declines any liability should
these safety measures not be observed.
Page 5 of 16