Konica Minolta bizhub 751 User Manual page 42

Using copy functions
3
Touch the button for the desired settings, and then touch [Position Setting].
4
Select the desired position.
– Touch [Auto] to automatically determine the stapling or hole-punching position according to the
orientation of the loaded original. The paper is stapled or holes are punched along the long side of
the paper if the original length is 297 mm or less or along the short side of the paper if the original
length is more than 297 mm.
When the "2 Position" Staple setting is selected
5
Touch [OK], and then touch [OK] in the next two screens that appear. Otherwise, touch [Main Screen].
The Basic screen appears again.
Note
The number of punched holes differs depending on the country (region) where the unit is installed. For
details, consult your service representative.
751/601
2
2-17