Removal Of The Front Cover - JVC LX-P1010ZU Service Manual

LX-P1010ZU/ZE
Assembly Note:
1. Make sure that the Joint Plate R, L and the Ballast Holder
are in their original position as shown in Fig. 2-2-7.
2. Be extra cautious during operation not to damage the Detect
Switch (Lamp Cover Switch) provided on the Portion (a) of
the Main PWB as shown in Fig. 2-2-8.
2.2.6.Removal of the Power Fan
1. Carefully pull out the Power Fan with the Fan Piece as shown
in Fig. 2-2-9.
Assembly Note:
1. Installing the Power Fan so that the name plate faces in.
2. Make sure that the connector cable of the power Fan is in
the original position as shown in Fig. 2-2-9.
7 (PA014)
Fig. 2-2-8
Fig. 2-2-9

2.2.7. Removal of the Front Cover

1. Remove 3 screws (F) as shown in Fig. 2-2-10.
2. Carefully pull and remove the portion (a) of the Front cover in
the direction of the arrow with paying attention to the Tab (A).
3. Remove the Front cover with paying attention to the Tab (B).
Fig. 2-2-10
2.2.8. Removal of the Lamp Fan Unit
1. Remove 3 screws (G) as shown in Fig. 2-2-11.
2. Remove the Lamp Fan Unit with the Front Barrier L and R.
Fig. 2-2-11
Assembly Note:
Installing the Lamp Fan Unit so that the name plate faces to
the side of the Front Cover.