Cleaning The Projection Lens; Connection Of The Flexible Cables To Trap Connector; How To Replace The Lithium Battery - JVC LX-P1010ZU Service Manual

1.5. Cleaning the Projection Lens

Use lens cleaning paper and cleaner available at your local camera
shop, etc.Dampen the cleaning paper with cleaner and gently wipe
the surface of the lens from the center outward to remove dust as
shown in Fig. 1-5-1.
Fig. 1-5-1
Note:
Do not use excessive force when cleaning the lens.
1.6. Connection of the Flexible Cables
to Trap Connector
Fig No. No. of Pins
P3501 30Pin
P3502 30Pin
P3503 30Pin
P2003 18Pin
(Removal and Installation of Flexible Cable)
• Removal
(Type A)
1. On the Trap Connector, swing the Locking Tab to release the
Trap portion of the Connector. Then pull Flexible Cable out
to remove as shown in Fig. 1-6-1.
(Type B)
1. On the Trap Connector, swing both ends of the Locking Tab
to release the Trap portion of the Connector. Then pull Flexible
Cable out to remove as shown in Fig. 1-6-1.
Fig. 1-6-1
PWB Type
Main PWB A
Main PWB B
Main PWB A
Main PWB B
• Installation
1. Insert the end of the Flexible Cable into the Trap Connector.
2. Without twisting the Cable, press the Locking Tab in into its
locked positions.
3. Gently and slightly pull up on the Cable to confirm if it is
installed firmly.

1.7. How to replace the lithium battery

7 Inserting the battery
Insert the lithium battery which is supplied with the remote
control unit, making sure that the polarities are correct.
WARNING:
Replace battery with CR2025 only. Use of another battery may present
a risk of fire or explosion.
Caution: Battery may explode if mistreated. Dispose of used battery
promptly. Keep away from children. Do not recharge, disassemble or
dispose of in fire.
1. While pushing the battery holder tab to the right, pull out the
battery holder.
2. Insert the battery into the battery holder so that the + side
is facing upward.
3. Insert the battery holder.
Note:
• Do not drop the remote control unit.
• Keep the remote control unit away from liquids.
• Remove the battery if not using the remote control unit for long
periods.
LX-P1010ZU/ZE
(PA014) 4