Disassembly Method Of Optical Unit - JVC LX-P1010ZU Service Manual

LX-P1010ZU/ZE
2.4. DISASSEMBLY METHOD OF
OPTICAL UNIT
2.4.1. Removal of the Polarizer Units
1. Remove 3 screws (A) to remove the Polarizer Red Unit, the
Polarizer Green unit and the Polarizer Blue Unit as shown in
Fig. 2-4-1.
Note:
1. Take extreme care not to damage the Polarizer Units, when
servicing.
2. Make sure that no dust gets on the Polarizer Units. Either blow
it away with air or clean the Polarizing Units with cleaning paper
moistened with lens cleaner if necessary.
1. After replacing the Polarizer Unit, adjustment is necessary
(Refer to 3.1. Initial Guide Line).
2. Make sure of the Mark color to distinguish the Polarizer Unit
(Red, Green, Blue) as shown in Fig. 2-4-2.
11 (PA014)
Fig. 2-4-1
Fig. 2-4-2
2.4.2. Removal of the Lamp House Unit
1. Remove a screw (B) as shown in Fig. 2-4-3.
2. Remove the Lamp Duct.
Fig. 2-4-3
3. Remove 2 screws (C) as shown in Fig. 2-4-4.
4. Remove the Fuse Holder.
5. Lift the Lamp House Unit up to release 2 projections.
Fig. 2-4-4
Assembly Note:
After Installing the Lamp House Unit, install the Temperature Fuse
and Fuse Holder in the original position as shown in Fig. 2-4-4.