JVC LX-P1010ZU Service Manual page 21

Lcd data projector

Hide thumbs Also See for LX-P1010ZU:

Table of Contents

LX-P1010ZU/ZE

Note:

This adjustment should be done in a darkroom.

• POLARIZER RED ADJUSTMENT

1. Supply Black Signal (0 %) and project on the screen.

2. Loosen a Screw (A) of Polarizer Red Unit.

3. Move the Polarizer Red Unit to the right and left so that the

whole screen becomes the blackest possible value, and

then tighten a Screw (A).

• POLARIZER GREEN ADJUSTMENT

1. Supply Black Signal (0 %) and project on the screen.

2. Loosen a Screw (B) of Polarizer Green Unit.

3. Move the Polarizer Green Unit to the right and left so that

the whole screen becomes the blackest possible value, and

then tighten a Screw (B).

• POLARIZER BLUE ADJUSTMENT

1. Supply Black Signal (0 %) and project on the screen.

2. Loosen a Screw (C) of Polarizer Blue Unit.

3. Move the Polarizer Blue Unit to the right and left so that the

whole screen becomes the blackest possible value, and

then tighten a Screw (C).

21 (PA014)

Fig. 3-4-17

(PA014) 20

Table of Contents

Lx-p1010ze