JVC LX-P1010ZU Service Manual page 11

LX-P1010ZU/ZE
2.2.10. Removal of the Speaker Unit
1. Detach the tape and carefully pull out the Speaker Unit as
shown in Fig. 2-2-13.
Assembly Note:
After the installation of the speaker, put on the tape in the
original position.
2.2.11. Removal of the Main Power PWB the
Ballast PWB, the Inlet PWB and the
Ballast Barrier-A
1. Carefully pull out the Main Power PWB, the Ballast PWB and the
Inlet PWB along with the Ballast Barrier-A as shown in Fig. 2-2-14.
2. Disconnect 3 connectors P1151, P1201, P1302 and P1303 as
shown in Fig. 2-2-15.
9 (PA014)
Fig. 2-2-14
Fig. 2-2-15
Assembly Note:
Make sure that the Main Power PWB, the Ballast PWB the
Inlet PWB and the Ballast Barrier-A are in the original position
as shown in Fig. 2-2-16.
Fig. 2-2-16