Connect And Set Up A Beolink System - Bang & Olufsen BeoVision 7 Manual

16
Make link connections
To distribute video signals to link rooms, it
is necessary to connect an RF Link
Amplifier to the main room TV and a link
1
room TV.*
Switch on the system modulator
If you have an audio setup, such as a
BeoLink Active/Passive, and you set up a non-
linkable TV in the same room, you must set
the system modulator to 'ON'. The factory
setting is 'AUTO', which must be used if you
are using a linkable Bang & Olufsen TV.
Change the link frequency
If, e.g., a TV channel in your area is
broadcasted on the same frequency as the
factory setting for the BeoLink system;
599 MHz, you must tune the system
modulator to an unoccupied frequency.*
Useful hints
1
*Connected If an audio system is already connected to the MASTER LINK socket and
equipment you wish to connect more equipment, the Master Link cable must be
split in two and joined with the cable from the link room using a special
junction box. Contact your Bang & Olufsen retailer for assistance.
2
*Link frequency When you change the link frequency in the main room TV, make sure
that the link frequency in the link room corresponds to it.

Connect and set up a BeoLink system

Connect and set up a BeoLink system to see pictures and hear sound in link
rooms. You can, for example, connect the living room TV to another video
system or to a set of speakers in another room.
TV
RF Link
Amplifier
Select 'LINK' in
Select 'OPTIONS' in
'CONNECTIONS'
'TV SETUP' menu
Select 'LINK' in
Select 'OPTIONS' in
'CONNECTIONS'
'TV SETUP' menu
2
Connect the Master Link cable to the available
socket marked MASTER LINK on the TV.
To distribute video signals to link rooms,
connect an ordinary aerial cable to the socket
marked LINK TV on the main connection
panel. Then run the aerial cable to the RF Link
Amplifier and the Master Link cable to the
MASTER
LINK link room. Follow the instructions enclosed
with the link room equipment.
LINK TV
Select
'MODULATOR'
menu
Select
'FREQUENCY'
menu
NOTE! HDMI, VGA and Y – Pb – Pr signals
cannot be distributed from a main room TV
to the link room system.
Reveal 'ON' Accept
Find unused Accept
frequency