Supermicro X7SLM+ User Manual page 69

Serial Port Mode
This feature allows the user to set the serial port mode for Console Redirection.
The options are 115200 8, n 1; 57600 8, n, 1; 38400 8, n, 1; 19200 8, n, 1; and
9600 8, n, 1.
Flow Control
This feature allows the user to set the flow control for Console Redirection. The
options are None, Hardware, and Software.
Redirection After BIOS POST
Select Disabled to turn off Console Redirection after Power_On_Self_Test (POST).
Select Always to keep Console Redirection active all the time after POST. (Note:
This setting may not be supported by some operating systems.) Select Boot Loader
to keep Console Redirection active during POST and Boot Loader. The options
are Disabled, Boot Loader, and Always.
Terminal Type
This feature allows the user to select the target terminal type for Console Redirec-
tion. The options are ANSI, VT100, and VT-UTF8.
VT-UTF8 Combo Key Support
Select Enabled to allow VT-UTF8 combination key support for ANSI/VT100
terminals. The options are Disabled and Enabled.
Sredir Memory Display Delay
This feature defines the length of time in seconds to display memory information
during remote access. The options are No Delay, Delay 1 Sec, Delay 2 Sec, and
Delay 4 Sec.
Trusted Computing (X7SLM+ only)
TCG/TPM Support
Select Yes on this item and enable the TPM jumper (JPT1) on the motherboard
to enable TCG (TPM 1.1/1.2)/TPM support in order to improve data integrity and
network security. The options are No and Yes.
If this feature is set to Yes, the following items will display:
Execute TPM Command
Select Enabled to allow the user to change executable TPM commands and TPM
settings. Select Don't Change to keep the current TPM settings. The options are
Don't Change, Enabled, and Disabled.
4-15
Chapter 4: AMI BIOS