Supermicro X7SLM+ User Manual page 59

ACPI Configuration
Use this feature to configure ACPI (Advanced Configuration and Power Interface)
power management settings for your system.
ACPI Aware OS
Select Yes to enable ACPI support for the OS. Disable this feature if ACPI is not
supported by your OS. The options are Yes and No.
ACPI Version Feature
This feature allows the user to select ACPI Version for the system. The options
are ACPI 1.0, ACPI 2.0, and ACPI 3.0.
Watch Dog Function
Select Enable to enable Watch Dog Timer and allow the system to reboot when it
is inactive for more than 5 minutes. The options are Enabled and Disabled.
Restore on AC Power Loss
Use this feature to set the power state after a power outage. Select Power-Off for
the system power to remain off after a power loss. Select Power-On for the system
power to be turned on after a power loss. Select Last State to allow the system to
resume its last state before a power loss. The options are Power-On, Power-Off
and Last State.
MPS Revision
This feature allows the user to specify the version of the Multi-Processor Specifica-
tion (MPS) the motherboard is using. The options are 1.4 and 1.1.
Interrupt 19 Capture
Interrupt 19 is the software interrupt that handles the boot disk function. When this
item is set to Enabled, the ROM BIOS of the host adaptors will "capture" Interrupt
19 at boot and allow the drives that are attached to these host adaptors to func-
tion as bootable disks. If this item is set to Disabled, the ROM BIOS of the host
adaptors will not capture Interrupt 19, and the drives attached to these adaptors
will not function as bootable devices. The options are Enabled and Disabled.
Processor & Clock Options

!
Warning When you first enter the Advanced Setup screen, the Setup
Warning will be displayed. Follow the instructions given on the screen to
set the correct value for each item to make sure that the system functions
properly.
4-5
Chapter 4: AMI BIOS