Heating Your Room - Samsung ACH2400C Owner's Instructions & Installation Manual

Heating Your Room

You must select the HEAT mode if you wish to adjust the :
N Heating temperature
N Fan speed when heating
1 If necessary, press (ON/OFF) button.
N The On/Off indicator on the wired remote controller
Result:
N
comes on.
N The air conditioner runs in the mode selected when
N
the unit was last used.
IMPORTANT
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
N Plugged in
N Stopped
lt will start up normally after three minutes.
2 To select the HEAT mode, press the Mode button until
at the top of the wired remote controller.
N The air conditioner runs in HEAT mode.
Result:
N N o o t t e e You can change modes at any time.
N N o o t t e e
3 To adjust the temperature, press the Temperature buttons one or more times
until the required temperature is displayed. Possible temperatures are between
O O
61 F and 86 F inclusive.
N Each time you press Temperature buttons:
Result:
- The temperature is adjusted by 1
N The air conditioner starts heating, provided that the room
N
temperature is lower than the selected temperature ; the fan
N
will, however, operate.
4 Select the fan speed by pressing the Fan button one or more times until
the intended value is displayed :
Automatic(rotated :
Low
Medium
High
5 To control the direction of the air flow, refer to page 17.
is displayed
O
F.
➔ ➔
)
15
E-