Heating Your Room - Samsung AQT18PJG Series User Manual

Heating Your Room

You must select the Heat mode if you wish to adjust the:
◆ Heating temperature
◆ Fan speed when heating
1
If necessary, press the
Result: ◆ The operation indicator on the indoor unit lights up.
◆ The air conditioner starts up in the mode selected when
the unit was last used.
◆ The indoor unit beeps.
CAUTION The air conditioner is fitted with a protection mechanism
to prevent the unit from being damaged when it is started
immediately after being:
◆ Plugged in
◆ Stopped
It will start up normally after 3 minutes.
2
If the is not displayed at the top of the remote control, press the
on the remote control one or more times until it appears.
Result: ◆ The indoor unit beeps each time you press the
◆ The air conditioner runs in HEAT mode.
Note You can change modes at any time.
3
To adjust the temperature, press the
the required temperature is displayed.
Possible temperatures are between 16°C and 30°C inclusive.
Result: ◆ Each time you press the
- The temperature is adjusted by 1°C
- The indoor unit beeps
◆ The air conditioner starts heating, provided that the room
temperature is lower than the desired temperature
(selected temperature+3°C).
◆ If the room temperature reaches the set temperature, the air
conditioner stops heating, but the fan is still operating.
4
Select the fan speed by pressing the
the required setting is displayed:
Automatic (rotated :
Low
Medium
High
Result: ◆ Each time you press the
◆ For the first three to five minutes, the fan operates
very slowly until the air has been sufficiently warmed. Once
the correct temperature has been reached, the fan is
automatically set to the required speed.
5 To control the direction of the air flow, refer to page 17.
(On/Off ) button.
button one or more times until
button:
button one or more times until
button, the indoor unit beeps.
button
button.
)
11
E-