Table of Contents
Advertisement
Heating Your Room
You must select the Heat mode if you wish to adjust the:
N Heating temperature
N Fan speed when heating
1
If necessary, press the
N The operation indicator on the indoor unit lights up.
Result:
N The air conditioner starts up in the mode selected when
the unit was last used.
N The indoor unit beeps.
The air conditioner is fitted with a protection mechanism
IMPORTANT
to prevent the unit from being damaged when it is started
immediately after being:
N Plugged in
N Stopped
It will start up normally after three minutes.
2
If the
is not displayed at the top of the remote control, press the
button on the remote control one or more times until it appears.
N The indoor unit beeps each time you press the
Result:
N The air conditioner runs in HEAT mode.
N N
N N
o o
o o
t t
t t
e e
e e
You can change modes at any time.
3
To adjust the temperature, press the
until the required temperature is displayed.
Possible temperatures are between 16°C and 30°C inclusive.
N Each time you press the
Result:
- The temperature is adjusted by 1°C
- The indoor unit beeps
N The air conditioner starts heating, provided that the room
temperature is lower than the desired temperature
(selected temperature+3°C).
N If the room temperature reaches the set temperature, the air
conditioner stops heating, but the fan is still operating.
4 Select the fan speed by pressing the
until the required setting is displayed:
Automatic (rotated :
Low
Medium
High
N Each time you press the
Result:
N For the first three to five minutes, the fan operates very
slowly until the air has been sufficiently warmed. Once the
correct temperature has been reached, the fan is automatically
set to the required speed.
5
To control the direction of the air flow, refer to page 17.
(On/Off) button.
button one or more times
button:
button one or more times
button, the indoor unit beeps.
button.
)
11
E-
Advertisement
Table of Contents
