Wired Remote Controller Installation (Optional) - Samsung ACH2400C Owner's Instructions & Installation Manual

Wired Remote Controller Installation (Optional)

Accessories
Wired Remote Cable-Tie(2)
Controller(1)
1 Disassemble the wired remote controller by using two grooves
on the top of it.
2 Secure the rear cover of the wired remote controller on the wall with two
screws.
3 Connect the R1, R2 and R3 terminals in the wired remote controller to
each R1, R2 and R3 terminals on the electrical component box.
C C C C A A A A U U U U T T T T I I I I O O O O N N N N
N
Do NOT keep the wired remote controller cables with a 220V
cable because the remote controller cables have low voltage.
N
Do NOT input 220V power to the R1, R2 and R3 in the wired
remote controller.
N N o o t t e e
N N o o t t e e
Cable Specifications
Cable type
Size of cables
Max. length of electric wires from the
indoor unit to the wired remote controller
4 Reassemble the wired remote controller.
C C A A U U T T I I O O N N
C C A A U U T T I I O O N N
N The optional kits must be installed by an installation specialist.
N Before installing the optional kits, ensure that you have turned
off the main power.
N All optional kits cables should be installed according to the
national wiring rules and you must install them in the wall not
to be touched by users.
Cable Clamp(5) TH M4 X 16 Tapped
Screw(7)
Double-insulation, 3G
0.3mm 2 ~0.75mm
100m(109 yd)
2
Indoor Unit
Wired
Remote
Controller
59
E-