Quick Guide; Getting Started - Volvo VNS Quick Manual

Volvo navigation system
Hide thumbs Also See for VNS:
Table of Contents

Advertisement

01 Quick guide

Getting started

01
Activating the system
With the ignition switched on (see the section
"Ignition modes" in the Owner's Manual):
1. Press the remote key fully into the ignition
slot to activate ignition mode I.
2. If the navigation system does not start
within a few seconds, press NAV on the
center console control panel.
Disclaimer
When the system is started, it displays the
following text, which must be confirmed:
Press the OK button.
For additional information, see page 15.
NOTE
The system can be used even when the
engine is not running. To help avoid bat-
tery drain, the system should be turned off
when it is not in use.
8
Demo mode (simulated guidance)
The system has a Demonstration mode that
can be used to help acquaint you with the
navigation system, see page 61.
Navigation system options
The Volvo Navigation System can be oper-
ated in several ways:
With the right side steering wheel keypad
With the controls in the center console
With a remote control
With voice commands
See page 23 for a description of the func-
tions.
The navigation system also contains options
for adjusting map, guidance, and system set-
tings. For detailed information, see page 53.
Main commands
The controls in the steering wheel keypad are
used in both of the following examples (Guid-
ance to a street address and Guidance to
Points of Interest (POI)).
Navigate and make selections by turning
the thumb wheel (1).
Confirm a selection by pressing the
thumb wheel (written in the following
examples as "+ OK").
Go back in the menus or cancel by press-
ing EXIT.
Controls in the center console
The following apply if the center console con-
trols are used instead of the steering wheel
keypad:

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents