01 Quick Guide; Getting Started - Volvo V70 Operating Manual

01 Quick guide

Getting started

01
Navigation control/remote control
The navigation control is located on the right
rear side of the steering wheel, see page 20.
The buttons on the remote control have the
same function as the navigation control on the
steering wheel.
•
Navigation control – Use this (or the arrow
keys on the remote control) to navigate up,
down, left, or right among the various
menu selections and alternatives, and to
move the cross hairs on the map.
•
ENTER – Confirms or activates a selection.
•
BACK – Press this key to go to the previous
menu or to undo a selection.
NOTE
For reasons of traffic safety, only the menu
alternatives Next destination, Current
position and Shut down
while the vehicle is in motion.
Certain functions in the Shortcut menu are
also available while the vehicle is in motion,
see page 28.
1
On models with the optional Keyless Drive, press the START/STOP ENGINE button one time, so that the ignition system is at least in "Accessory" mode (mode I).
8
Activating the system
The remote key must be inserted in the ignition
1
slot (see the vehicle's Owner's Manual).
1. Press the remote key into the ignition slot.
2. Press briefly on the START/STOP
ENGINE button.
3. If the screen does not deploy, press
BACK or ENTER.
It may take the system several seconds to
determine the vehicle's location after the key
has been inserted into the ignition slot. When
this has been done, the vehicle's postion will
be indicated by a blue triangle.
NOTE
The system can be used even when the
engine is not running. To help avoid battery
are available drain, the system should be turned off when
it is not in use.
Guidance to a street address
Set destination Press BACK to dis-
play the main menu.
Use the navigation
control to go to
destination
Press ENTER.
Address Go to Address
press ENTER.
State/City Go to State
and press ENTER.
Select letters in the
list to specify the
state and city in
which the street
address is located.
Press ENTER.
Street Go to Street
press ENTER.
Street numbers Go to Numbers
press ENTER
Set
.
and
or City
and
and