Table of Contents
Advertisement
Selecting a Ring Tone
The ability to change your ring tone is helpful in close-quartered environments. If
your ring tone is unique, you can quickly identify when a call is ringing on your end-
point.
To select the type of ring tone for your endpoint:
On standby mode, press
desired ring type. There are three ring tones and vibrate ringer available.
NOTE:
When your endpoint is set to vibrate and the handset is charging in the base,
the endpoint rings when a call comes in and the call is answered when you lift the hand-
set off of the base.
Turning the Handset Ringer On/Off
You can temporarily turn the handset ringer off.
To turn the ringer off:
In standby mode, press and hold
The Ring Off (
Returning to Default Operation
You can return your endpoint to default levels at any time. This feature returns vol-
umes to default levels; cancels Do-Not-Disturb, and manual call forwarding.
To return your endpoint to default:
Dial
3
9
A
T
BOUT THE
ELEPHONE
As you can see, your INT1400 and Inter-Tel telephone system come equipped with a
lot of "bells and whistles." To help you understand what everything means, it is rec-
ommended that you read the following information before you use your phone:
•
Your telephone system may be programmed for one or two dial tones. Systems
with two dial tones have one for intercom calls and one for outside calls.
•
Many features "time out" if you wait too long before performing the next step. If
this happens, you must hang up and start again.
INT1400 Cordless Telephone User Guide
on the side of the handset until you hear the
RING/VOL
RING/VOL
) icon appears in the display.
.
4
S
YSTEM
on the side of handset for two seconds.
17
Advertisement
Table of Contents
