Color Temperature - Sony PMW-500 Operation Manual

b Zoom position (when the lens is
mounted)
Indicates the zoom position of the zoom lens in
the range from 0 to 99.
c Focus position (when the serial lens is
mounted)
Indicates the focus position as distance to the
subject (in units of m).
d Green tally
Lights when the camcorder is the following
states.
• MAINTENANCE >Camera Config >HD-SDI
Remote I/F is set to [G-Tally] in the setup menu
and a recording control signal is output from the
HD/SD SDI OUT connector.
• When the Picture Cache mode is enabled
• Green tally signal received (when a camera
adaptor installed on this camcorder is connected
to a camera extension unit)
e Media status
Displays the name of the currently active media
slot (A or B).
f Special recording mode/operation
status
Indicates the current special recording mode/
operation status as follows.
Indication Meaning
zREC
Recording in progress
STBY When recording is on a break in
Clip Continuous Rec mode or
standby in other modes
CONT Standby for next recording in Clip
Continuous Rec mode
zCACHE
Standby in Picture Cache mode
zINT REC Recording in progress in Interval
Recording mode
zINT STBY Standby for next recording in
Interval Recording mode
INT STBY Standby in Interval Recording
mode
zFRM REC Recording in progress in Frame
Recording mode
zFRM Standby for next recording in
STBY Frame Recording mode
FRM STBY Standby in Frame Recording mode
zS&Q REC Recording in progress in Slow &
Quick Motion mode
Indication Meaning
S&Q STBY Standby in Slow & Quick Motion
mode
zCALL
Being called from a connected
device
BREVIEW During recording review
g Wireless receiver reception level
When a wireless receiver is installed in the
camcorder, "W" appears together with four
segment reception level indicators for each of the
channels (1 to 4) that can be used by the receiver.
The indications are as follows.
In normal situation: The number of white
segments indicates the strength of the signal
level.
Muting (for an analog receiver) or error rate
aggravation (for a digital receiver): The
number of gray segments indicates the
strength of the signal level.
Reception level over peak: "P" is displayed
instead of the indicators.
Tuner battery is low: The channel number and
indicator of the corresponding channel
1)
flash.
1) When an optional DWR-S01D is used
h Battery remaining/voltage capacity
The following is displayed depending on the type
of power source.
Type of power What is displayed
source
InfoLithium Remaining battery capacity icon
battery and remaining recording time
Anton Bauer Remaining battery capacity (%
battery indication)
Other type than Input voltage
above
i External power input
Appears when power is supplied from an external
power source connected to the DC IN connector.
j Color temperature
Displays a color temperature calculated from the
gain of R and B, in the range 1.5 K to 50.0 K (in
steps of 0.1 K). The +/– signs may be displayed
depending on the Offset White setting (see
page 96).
No display: Offset White is OFF
+: The value of Offset White is greater than
3200K.
Locations and Functions of Parts and Controls
1)
29