Sony PMW-500 Operation Manual page 43

2
Insert the DWR-S01D or WRR-855S
into the housing slot, and fasten the four
fixing screws.
DWR-S01D or WRR-855S
3
Set the AUDIO IN selector for the
channel to which you want to input
audio signal to WIRELESS (see
page 22).
To fit the WRR-862 (when using a BP-
GL65/GL95/L60S/L80S Battery Pack)
1
Attach the WRR tuner fitting (not
supplied; service part number: A-8278-
057-B) to the back of the camcorder.
1 Use a Phillips type screwdriver to
tighten the four screws placed in the
tuner fitting. For three of these screws,
insert the screwdriver through the
corresponding hole and tighten the
screw.
Note
Make sure that all four screws are fully tightened.
2 Loosen the adjustment screws on the
tuner fitting.
3 Adjust the tuner fitting position for a
BP-GL65/GL95/L60S/L80S Battery
Pack to be attached, and tighten the
adjustment screws to fix its position.
4 Attach the mount plate supplied with
the WRR-862.
About the WRR tuner fitting (service part
number: A-8278-057-B), contact a Sony service
or sales representative.
BP-GL65/GL95/L60S/L80S
Adjustment
screws
2
Attach the battery pack.
On how to attach the battery pack, see "To
attach the battery pack" on page 32.
3
Mount the tuner on the WRR tuner
fitting.
4
Connect the tuner power cord to the DC
OUT connector of the camcorder, and
the audio output cable to the AUDIO IN
CH-1 or CH-2 connector.
5
Set the switches as follows.
• Set the AUDIO IN selector for the channel
to which the audio output cable is attached
to MIC.
• Set the AUDIO IN CH1/CH2/CH3/CH4
switch for the channel to which the audio
output cable is connected to REAR.
If the XLR connection automatic detection
function is on, the input signal for audio
recording is selected automatically, and
therefore this setting is not required.
Preparing the Audio Input System
Mount plate
(supplied with
WRR-862)
Phillips type
screwdriver
WRR-862
43