Preparing The Audio Input System; Connecting A Microphone To The Mic In Connector - Sony PMW-500 Operation Manual

Carrying out the adjustment
1
Set the iris to manual.
2
Open the iris, position the supplied
flange focal length adjustment chart
approximately 3 meters (10 ft) away
from the camcorder, and arrange the
lighting to obtain a satisfactory video
output.
3
Loosen the fixing screws on the F.f or
F.B ring (flange focal length adjustment
ring).
4
Use manual or power zoom to set the
lens to telephoto.
5
Point the camcorder at the chart by
turning the focus ring and focus on it.
6
Set the zoom ring to wide angle.
7
Turn the F.f or F.B ring until the chart
is in focus, being careful not to disturb
the focus ring.
8
4
Repeat steps
in focus all the way from wide angle to
telephoto.
9
Tighten the F.f or F.B ring fixing
screws.
40

Preparing the Audio Input System

7
to until the chart stays
Preparing the Audio
Input System
Connecting a Microphone to the
MIC IN Connector
You can attach the optional ECM-680S stereo
microphone to the microphone holder of the
optional HDVF-20A viewfinder.
1
Loosen the screw and open the
microphone holder clamp.
Microphone holder clamp
2
Place the microphone in the
microphone holder.
1 Wind the microphone spacer around
the microphone, while peeling off the
protective sheets on both sides of the
microphone spacer.
2 Place the microphone in the holder so
that "UP" is at the top.
3 Close the microphone holder.
4 Tighten the screw.