Switching off the cooking zones Programming the cooking duration Timer Control panel lock Switching off the hob “Demo” mode 7HKEC 647 X RU/HA Practical advice on using the appliance Safety devices Practical cooking advice Precautions and tips, 10 General safety...
Installation Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe operation, installation and maintenance of the appliance. min. 20 mm Please keep these operating instructions for future reference. Pass them on to any new owners of the appliance.
Fixing Other types of connection on a perfectly level If the mains supply corresponds with one of the The appliance must be installed supporting surface. following: Voltage and mains frequency Any deformities caused by improper fixing could • 400V - 2+N ~ 50 Hz affect the features and operation of the hob.
Description of the appliance Control panel The control panel described in this manual is only a representative example: it may not exactly match the panel on your appliance. TIMER* indicator light INCREASE PROGRAMME TIMER* POWER button display COOKING ZONE PROGRAMMED* BOOSTER* indicator light indicator light...
Start-up and use Switching off the cooking zones The glue applied on the gaskets leaves traces of grease on the glass. Before using the appliance, we recommend you remove these with a special non- To switch off a cooking zone, select it using the abrasive cleaning product.
+ + + + + - - - - - To cancel a programme, follow the above - - - - - • Press and hold the buttons instructions. At step 2, press the button: the simultaneously for 6 seconds. When the 6 seconds have elapsed, the ON/OFF and duration decreases progressively until it reaches 0 CONTROLS LOCKED indicator lights will flash for...
Safety switch • Avoid using the same cookware which has been used on gas burners: the heat concentration on The appliance has a safety switch which gas burners may distort the base of the pan, automatically switches the cooking zones off after causing it not to adhere correctly.
Precautions and tips This appliance has been designed and manufactured in a high sugar content. Be especially careful when using compliance with international safety standards. The plastic film and aluminium foil or packaging: if placed on following warnings are provided for safety reasons and surfaces which are still hot, they may cause serious must be read carefully.
Care and maintenance Switching the appliance off Stainless steel frame (only in models with outer frame) Disconnect your appliance from the electricity supply before carrying out any work on it. Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus.
The induction system is the quickest existing way of cooking. Unlike traditional hotplates where the cooking zone heats up, with the induction system heat is generated directly inside pans which have ferromagnetic bases. Hobs 7HKEC 647 X RU/HA Cooking zone Power (W) Diameter (mm)