Hitachi C 12FSA Technical Data And Service Manual page 35

Disassembly
Item
No. spots
1 Turn table, base
ass'y
Disassembly procedure
1. Remove the Knob Bolt M8 x 60 [94] and then remove Guard Ass'y
(A) [93].
2. Loosen the Clamp Lever [83], remove the Clutch Screw [81], turn
the Bolt (Left Hand) M12 x 165 [84] and remove it from the Screw
Holder [88A]. Remove the Hinge Shaft [77] from the Turn Table
[9A]. This enables you to remove the head and slide mounted on
Holder (A) [68] together from the Turn Table [9A].
3. Remove the four Bolts (W/Washers) M8 x 35 (Black) [19], Fence
(A) [47A] and Fence (B) [21A].
4. Remove Shaft (A) [29] and then remove the Turn Table [9A] from
the Base Ass'y [23A].
5. Remove the Side Handle [41], pull out the Retainer Ring (E-type)
for D7 Shaft [43] and remove the Shaft [42A].
6. Remove Indicator (B) [5], Indicator (C) [7], Indicator [36B], Spacer
[38] and Table Insert [2] from the Turn Table [9A] by removing each
mounting screw.
7. Remove Holder (B) [22] and Base Rubber [26] from the Base
Ass'y [23A] by removing each mounting bolt and screw.
--- 31 ---
Necessary tools
Flatblade
screwdriver
19 mm (3/4")
box wrench
19 mm (3/4")
box wrench
Small pliers
Phillips
screwdriver
10 mm x 13 mm
(
13/32" x 33/64"
double-head
wrench
Phillips
screwdriver