Packing - Hitachi C 12FSA Technical Data And Service Manual

10. PACKING

(Different by areas)
(1) Preparation
Remove the side handle, holder, stopper, holder
(B) and dust bag from the main unit.
Then swivel the turn table through 57˚ toward the
right. Push the guard back.
(See Fig. 51.)
(2) How to install packing (B) and (G)
Slide the head section toward the operator, insert
packing (B) between the hinge and holder (A).
Push the head back and secure the slide in
position with packing (B) inserted by means of the
8 mm knob bolt. Then place the packing (G)
under the hinge. (See Fig. 52.)
(3) How to install packing (F) and (H)
Place packing (F) under the motor and packing (H)
under the head section. Push the head section
down. Insert the locking pin while pressing the
packings (F) and (H) to secure the head section in
position. (See Figs. 53 and 54.)
Motor
Packing (F)
Place the packing so that the motor
Fig. 53
housing fits in the groove.
Dust bag
Holder (B)
Holder
Push the guard back.
Packing (B)
M8 knob bolt
Hinge
Packing (G)
Head section
Packing (H)
Push down the head section and insert the locking
Fig. 54
pin to secure the head section at the lower position.
--- 28 ---
Holder
Swivel the
turn table 57˚
to the right.
Side handle
Fig. 51
Fig. 52
Locking pin
Holder (A)
Fix the holder
(A) securely
with the
clamp lever.
Stopper