Connecting Wires To Terminals - Kenwood KDC-MP338 Instruction Manual

Connecting Wires to Terminals

Steering remote control (Light Blue/Yellow)
(KDC-X492/MP438U/MP408U only)
REMO.CONT
To use the steering wheel remote control feature, you need to an exclusive
remote adapter (not supplied) matches your car is required.
When this terminal is not in use, leave its cap on.
Fuse (10A)
Wiring harness
(Accessory1)
Power control/Motor antenna control wire
(Blue/White)
TEL mute wire (Brown)
Motor antenna control wire (Blue)
Dimmer control wire (Orange / White)
(KDC-X492/MP438U/MP408U only)
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
Front preout
(KDC-MP338 only)
FRONT
FM/AM antenna input
(KDC-X492/MP438U/MP408U)
FM/AM antenna input
(KDC-MP338)
To Kenwood disc changer/
External optional accessory
If no connections are made, do not let the wire come out from the tab.
P.CONT
MUTE
ANT.
CONT
ILLUMI
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
L
Connect either to the power control terminal when using the
optional power amplifier, or to the antenna control terminal
in the vehicle.
Connect to the terminal that is grounded when either the
telephone rings or during conversation.
⁄
To connect the Kenwood navigation system, consult
your navigation manual.
Depending on what antenna you are using, connect either to
the control terminal of the motor antenna, or to the power
terminal for the booster amplifier of the film-type antenna.
To car light control switch
Ignition key switch
Car fuse box
ACC
KDC-X492/MP438U
Rear preout Rear preput
R
Front preout Front preput
SubWoofer preout Subwoofer preput
KDC-MP408U
L R
Rear/Subwoofer preput
Rear preout/SubWoofer preout
KDC-MP338
L
Rear preout/SubWoofer preout Rear/Subwoofer preput
R
Car fuse box
(Main fuse)
+
–
Battery
|
English
19