Change Supervisor/User Password; Auto-Detect Hard Disk - Xycom SBC-370 Board Processor Manual

CHANGE SUPERVISOR/USER PASSWORD

Set a password that is used to protect your system and Setup Utility. Supervisor
Password has higher priority than User Password. Once you setup the password,
the system will ask you to enter the password every time you enter the BIOS SETUP.
If you enter the BIOS SETUP with the Supervisor Password, you can access every
setup option on the main menu. With a User Password, you can only choose three
setup options (Change User Password, Save Setting and Exit, and Exit Without Saving). To disable
these passwords, enter the BIOS SETUP menu with the Supervisor Password and
then press the Enter key instead of entering a new password when the Enter Password
prompt appears.

AUTO-DETECT HARD DISK

This option detects the parameters of an IDE hard disk drive (HDD sector, cylin-
der, head, etc.) automatically and will put the parameters into the Standard
CMOS Setup screen. Up to 4 IDE drives can be detected and the parameters will
be listed in the box. Press Y if you accept these parameters. Press N to skip to the
next IDE drive.
Note:
be detected. In this case, you need to enter the correct parameters manually or low-level
format the disk.
37
If your IDE HDD was formatted in a previous system, incorrect parameters may
AMI BIOS Setup Menus