Setup; Hardware Setup; Intel ® Iq80219 Hardware Setup Flow Chart; C.2 Setup - Intel IQ80219 Board Manual

General purpose pci processor evaluation platform
Table of Contents

Advertisement

C.2

Setup

C.2.1

Hardware Setup

Use
Figure 28
hardware.
Connect the Raven to the host via the parallel port and to the evaluation board via the 20-pin
JTAG connector.
Note: The parallel port must be configured to EPP mode for the Macraigor Raven to work properly.
The parallel port setting can be changed in the BIOS setup program or in Control Panel. More
information on the Raven can be found at the Macraigor web site. Test software for the Raven is free
and available for download at:
http://www.ocdemon.net/Merchant2/merchant.mv?Screen=CTGY&Store_Code=MTS&Category_C
ode=pinouts.
Connect a serial cable from the evaluation board to the host.
Note: The serial cable connects to the evaluation board with an RJ11 connector and connects to the host
computer serial port via an RJ11 to DB9F adaptor. The serial port configuration is covered in the
configuration section below.
The IQ80219 plugs into a bus master PCI or PCI-X slot on the backplane or platform.
Note: There are many dip switches on the evaluation board which are used to configure the IBM bridge. Use
the dip switch and jumper sections of the Intel
3.10.2 to configure these switches. A work sheet is highly recommended when working out the switch
settings, Since there are a large number of switches, a record of the settings and the reasons for their
selection very useful. Check the system requirements of Microsoft Visual Studio and ATI Code|Lab to
make sure that the host is sufficient. The platform or backplane must have a 3.3 volt PCI-X or PCI slot.
The evaluation board is not 5 volt tolerant and damage occurs when 5 volts are applied.
®
Figure 30.
Intel
IQ80219 Hardware Setup Flow Chart
Board Manual
Intel® IQ80219 General Purpose PCI Processor Evaluation Platform
and the rest of the Intel
Serial Cable
Backplane or PCI-X Platform
®
IQ80219 Evaluation Platform Board Manual, to set up the
®
IQ80219 Evaluation Platform Board Manual, section
Host
JTAG
Evaluation Board
Getting Started and Debugger
Parallel Port Cable
20-Pin JTAG Connector
107

Advertisement

Table of Contents
loading

Table of Contents