Arm Extended Debugger - Intel IQ80219 Board Manual

2.6.5

ARM Extended Debugger

For further information on the AXD Debugger, refer to the content of the ARM ADS. This setup
assumes that Angel is Flashed on the board:
Description:
Start:
Assumptions: ARM Developer Suite (ADS) is loaded to Win32 Host, Angel is Flashed to ROM,
Following are the steps from setup to running a project file that has been previously created and
named Worchester.mcp:
1. From Windows start menu:
a. Programs -> ARM Developer Suite v1.1 -> Metrowerks CodeWarrior
2. From CodeWarrior open project and start debugger:
a. File -> Open (All files) -> Worchester.mcp
b. Project -> Enable Debugger
c. Project -> Debug (AXD Interface comes up)
3. From AXD (ARM extended debugger) configure and connect:
a. Connect Host to Target with serial cable
Options -> Configure Target ... -> Set Target Environment = ADP
b. Load Image and Start
On AXD menu: File -> Load Image... -> File name: Cyclone.axf -> Open ->
c. Execute -> Select Go, Breakpoints
4. The LEDs now Flashes '80219'. You can set breakpoints and step to control speed or stop
location.
1. To be supplied separately.
Board Manual
Intel® IQ80219 General Purpose PCI Processor Evaluation Platform
Terminal emulator runs on host and communicates with the board via the serial cable.
Power up the target board. After the 'reset' is asserted, the two 7-segment LEDs
display blank. The time for reset is approximately 1 or 2 seconds.
Host com port is connected to board serial port ## and compiled project file
1
Worchester.mcp exists.
Select Configure
Select... , ARM Serial Driver, OK
Endian: Little
Configure... , Serial Port:= COM1, Baud Rate:=115200, OK, OK, OK
Getting Started
29